Built-up Roofing

/Built-up Roofing
Built-up Roofing 2018-01-02T23:52:41+00:00

Built-up Roofing

Material and system description

Built-up Roofing, bur

Statewide Roofing a Commercial Oklahoma Roofing Company install Built-up Roofing throughout Oklahoma for Commerical clients.

Built-up Roofing membranes, referred to by the acronym BUR, have been in use in the U.S. for more than 100 years. These roof systems are commonly referred to as “tar and gravel” roofs. BUR   systems generally are composed of alternating layers of bitumen and reinforcing fabrics that create a finished membrane. The number of plies in a cross-section is the number of plies on a roof: The term “four plies” denotes a four-ply roof membrane construction. Sometimes, a base sheet, used as the bottom-most ply, is mechanically fastened. Built up roofs generally are considered to fully adhere if applied directly to roof decks or insulation.

The reinforcing fabrics also are called roofing felts or ply sheets. Roofing felts are reinforced with either glass-fiber mats or organic mats. Felts are produced in a   standard width of 36 inches and metric width of about one meter.
The bitumen typically used in Built-up Roofing systems is asphalt, coal tar or cold-applied adhesive. The asphalt or coal tar is heated in a kettle or tanker and then applied by mop or mechanical spreader. Asphalt is a petroleum product refined from crude oil; coal tar is derived from the distillation of coal. Cold-applied adhesives typically are solvent-based asphalts that don’t have to be heated in a   kettle or tanker.

Built-up Roofing, bur

Statewide Roofing, A three generation family owned and managed Oklahoma Roofing Company install Built-up Roofing on commercial properties.

Surfacing for built-up roofing systems include aggregate (such as gravel, slag or mineral granules), glass-fiber or mineral surfaced cap sheets, hot asphalt mopped over the entire surface, aluminum coatings or Elastoplast coatings.

A roof system composed of a built-up roofing membrane with two or three plies and a polymer-modified bitumen membrane cap sheet is commonly referred to as “hybrid” system. NRCA considers this type to be a polymer modified bitumen membrane system. In Oklahoma call Statewide Roofing in for all your Built-up Roofing needs.

Material standards

NRCA does not make any recommendations about which product or manufacturer to use; however, NRCA does recommend that bitumen’s, felts and mats used for BUR systems meet standards established by ASTM International.

Contact Statewide Roofing today for a Commercial Built-up Roofing consultation.



Your Name (required)

Your Email (required)

Phone Number (required)

Property Type


Your Message